Upper Threading - Brother 885-X01 Manual De Instrucciones

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Replace the bobbin cover. Put the
6
projection into the race retainer groove
and push closed.
1
2
1 Groove
2 Projection

Upper threading

1 Spool pin
2 Thread guide (back)
3 Thread guide (front)
CAUTION
●
When threading the upper thread, carefully follow the instructions. If the upper threading is
not correct, the thread may become tangled or the needle may bend or break.
●
Never use a thread weight of 20 or lower.
●
Use the needle and the thread in the correct combination. For details on the correct
combination of needles and threads, refer to "FABRIC, THREAD, AND NEEDLE
COMBINATIONS" on page 17.
Turn off the machine.
1
Raise the presser foot lever.
2
1 Presser foot lever
2
2
3
4
1
• Make sure that the end of the thread comes
out from the cover toward the rear of the
machine (as shown in the illustration).
• Draw up the lower thread before starting
sewing. Refer to "Drawing up the lower
thread" on page 16 after threading the upper
thread.
1
4 Thread take-up lever
5 Mark on the handwheel
1
5
14