Electrical connection
I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
DISCONNECT POWER BEFORE SERVICING.
REPLACE ALL PARTS AND PANELS BEFORE OPERATING.
FAILURE TO DO SO CAN RESULT IN DEATH OR
ELECTRICAL SHOCK.
1
Disconnect power.
2
Remove terminal box cover.
3
Remove the knockout in the terminal box cover and install
a UL listed or CSA approved
B
C
B.
C.
Junction box cover screws
4
Run home power supply cable through strain relief, into
terminal box.
B
A
A.White wires
B. Black wires
C. UL listed wire connectors
5
Use UL listed wire connectors and connect black wires
(B) together.
6
Use UL listed wire connectors and connect white wires (A)
together.
I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
ELECTRICALLY GROUND BLOWER.
CONNECT GROUND WIRE TO GREEN AND YELLOW
GROUND WIRE IN TERMINAL BOX. FAILURE TO DO SO
CAN RESULT IN DEATH OR ELECTRICAL SHOCK.
7
Connect green (or bare) ground wire from home power
supply to yellow-green ground wire (D) in terminal box
using UL listed wire connectors.
8
Tighten strain relief screw.
9
Install terminal box cover.
10 Check that all light bulbs are secure in their sockets.
11 Reconnect power.
10
⁄
" strain relief.
1
2
A
A.
Knockout
Junction box cover
E
F
C
D
D. Green, Bare or Yellow/Green wires
E. Home power supply
F. UL listed or CSA approved ½" strain
relief
Complete installation
•
Attach the upper duct covers using 6 - 3.5x6.5 mm screws.
•
Place lower duct covers using one plastic bracket at each
side (4 needed).
•
The lower duct cover shall be secured to rangehood by 4
screws.
•
Install the grease filter and turn power on at service panel.
•
Check operation of the hood.
If range hood does not operate:
•
Check that the circuit breaker is not tripped or the house
fuse blown.
•
Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read
the "Description of the Hood" and "Control" sections.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.