Silverline 129659 Manual De Instrucciones página 7

• Sand evenly over the work surface. The machine works in a rotary motion so it is not necessary to
work with the grain
• Only use the sander 'flat on' to the work. Tilting the sander onto its edge will damage the
workpiece
Accessories
• A range of accessories for your sander polisher, including polishing sponges and lambswool
bonnets, sanding sheets and polishing compounds, is available from your Silverline stockist.
Spare parts can be obtained from www.toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any inspection,
maintenance or cleaning.
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised Silverline service centre. This advice also applies to extension cords
used with this tool
Cleaning
WARNING: Be especially careful to clean the machine thoroughly if used for both wood and
metal. Sparks from metal work can easily ignite wood dust.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth.
If available, use clean, dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol or
strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an authorised Silverline
service centre
Note: One set of Spare Carbon Brushes is supplied with this tool.
• To replace the brushes:
1. remove the Brush Access Caps (11) from both sides of the machine
2. Remove the worn brushes and replace
3. Replace the Brush Access Caps
• Alternatively, have the machine serviced at an authorised Silverline service centre
1500W Sander Polisher 180mm
Hook & loop surfaces
• Hook and loop surfaces need to be clean, free of dirt and foreign matter, such as hair, fibres, sand
etc.
• In order to provide adequate adhesion for securing accessories, hook and loop surfaces must be
in good condition
• When used extensively, hooks and loops will become elongated or broken, and the mechanism
cannot provide the required strength of adhesion anymore
Note: This sander's Hook & Loop Backing Pad (10) is NOT a warranty item. Replacements can be
obtained from www.toolsparesonline.com.
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: silverlinetools.com/en-GB/Support
Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
silverlinetools.com
7