Wire Feed Pressure; Changing/Loading Wire - ESAB Warrior Feed 304 Manual De Instrucciones

US
8.5

Wire feed pressure

Start by making sure that the wire moves smoothly through the wire guide.
Then set the pressure of the wire feeder's pressure rollers. It is important that the
pressure is not too great.
Fig 1
To check that the feed pressure is set correctly, you can feed out the wire against
an insolated object, e.g. a piece of wood.
When you hold the torch approx. 0.2" (5 mm) from the piece of wood (fig. 1) the
feed rollers should slip.
If you hold the torch approx. 2" (50 mm) from the piece of wood, the wire should
be fed out and bend (fig. 2).
8.6

Changing/loading wire

S
Open the side panel.
S
Disconnect the pressure sensor by folding it backwards; the pressure rollers
slide up.
S
Straighten out the new wire 0.4 - 0.8 inch (10-20 cm). File away burrs and sharp
edges from the end of the wire before inserting it into the wire feed unit.
S
Make sure that the wire goes properly into the feed roller's track and into the
outlet nozzle or wire guide.
S
Secure the pressure sensor.
S
Close the side panel.
bm55d1a
Ï Ï
Ï Ï Ï Ï
Ï Ï
Ï Ï
Fig 2
- 18 -
Ï Ï
Ï Ï
Ï Ï Ï Ï
Ï Ï
Ï Ï
© ESAB AB 2013