SN29402473_HT-S3800_QSG_EnFrEs.book 12 ページ 2016年4月25日 月曜日 午前9時46分
Setup
Speaker Setting
c
The speaker configuration of this unit is set to 5.1
channel by default. This setting is required if there
are speakers you do not intend to connect. The
b
sound intended for speakers you will not be
connecting is filtered to the other speakers.
a
1. Switch the input on the TV to that assigned to the
unit.
2. Press
3. Select Manual SP Setup - Speaker Setting and in
the following screen set NO for those speakers
you will not be connecting. Set the front speakers
to LARGE before trying to set the subwoofer to
NO.
0 Select the item with the cursors of the remote control
and press ENTER to confirm your selection (b). To
return to the previous screen, press
0 You should normally select SMALL for your speakers.
You cannot select NO for the front speakers.
4. To exit setup, press
12
(a).
(c).
1a. Speaker Setting
Front
SMALL
Center
[ SMALL ]
Surr
[ SMALL ]
Subwoofer:
YES
Return
(c).
HDMI Setup
c
ARC
When connecting to a TV that supports ARC (Audio
b
Return Channel), enable the ARC feature.
1. Switch the input on the TV to that assigned to the unit.
2. Press
(a).
a
3. Select HDMI Setup, and set ARC to ON in the next
screen.
0 Select the item with the cursors of the remote control
and press ENTER to confirm your selection (b). To
return to the previous screen, press
4. To exit setup, press
0 You may need to change some TV settings to use
the ARC feature. Please refer to the TV's operation
manual for directions on connections and setup for
the TV.
Standby Through
When the receiver is in standby, the HDMI input
signal selected here will be output to the TV by
HDMI. Select from the following Standby Through
items to set.
LAST: The HDMI input signal selected previously
will be output.
BD/DVD, CBL/SAT, STRM BOX, GAME: The
HDMI input signal selected here will be output.
OFF: Signal will not be output during standby.
(c).
4. HDMI Setup
a. ARC
ON
b. Standby Through
[
LAST
]
c. 4k60p Setting
Return
(c).