Maintenance; Fasteners - Campbell Hausfeld AT802000 Instrucciones De Operación

Maintenance

TECHNICAL SERVICE
For information regarding the opera-
tion or repair of this product, please
visit www.campbellhausfeld.com
FASTENER AND REPLACEMENT
PARTS
Use only genuine
Campbell Hausfeld
18 gauge fasteners (or equivalent - see
Fastener Interchange Information).
Use only genuine Campbell Hausfeld
replacement parts. Never substitute
parts. Do not use modifi ed parts or
parts which will not give equivalent
performance to the original equipment.
Tool performance, safety and durability
could be reduced. When ordering
replacement parts or fasteners, specify
by part number.

Fasteners

The following Campbell Hausfeld fasteners are available at local retail stores. For help locating any item, visit
www.campbellhausfeld.com Campbell Hausfeld fasteners meet or exceed ASTM Standard F1667.
Model Length
FB180030 1-1/4 inch
TOOL REPAIR
Only qualified personnel should repair
the tool, and they should use genuine
Campbell Hausfeld replacement parts
and accessories, or parts and accessories
which perform equivalently.
ASSEMBLY PROCEDURE FOR SEALS
When repairing a tool, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
reassembling, a few drops of 30W
non-detergent oil or equivalent, must
be added through the air line before
testing.
Shank Gauge Finish
18 Gauge Galvanized
STORAGE
The tool should be stored in a cool, dry
place.
Head
Brad / Brown
7
AT802000, CHG00189
Nails Per
Collation Stick
Adhesive 100
www.campbellhausfeld.com
Nails Per
Box
1000