Function Setting - Ibiza Light COMBI-FX3 Manual De Uso

Ocultar thumbs

Contenido

página de 37

/ 37
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

MANUAL - COMBI-FX3

CABLE CONNECTORS

Cabling must have a male XLR connector on one end and a female XLR connector on the other end.

DMX connector configuration

Termination reduces signal errors. To avoid signal transmission problems and interfe-

rence, it is always advisable to connect a DMX signal terminator.

CAUTION

Do not allow contact between the common and the fixture's chassis ground. Groun-

ding the common can cause a ground loop, and your fixture may perform erratically.

Test cables with an ohm meter to check correct polarity and to make sure the pins

are not grounded or shorted to the shield or each other.

Setting up a DMX Serial Data Link

1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the

controller.

2. Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the

input connector of the next fixture consisting of a (male) 3 pin connector.

3. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.

DMX address setting

Each fixture must have a specific starting address. When receiving signal transmission, every fixture will receive

channels control signals for its own starting address.

The user can set several fixtures to the same address or set up a separate address for every device.

If more than one fixture is set to the same address, all of them receive the same DMX channels signals. All

connected fixtures are jointly controlled; the controller can't control a device separately.

If every device is set to a different address, it will receive different DMX signals corresponding to its starting

address.

This device has 9 or 17 channels. So, if the device is set to 9CH and the first device's starting address is set to

1, second is 10 (1+9), third is 19 (10+9) and so on.

Control Panel

8.8.8.8.

The control panel is the mechanism for configuring the settings. It has a small LCD

screen and four buttons, which are described below.

Button Function

<MENU>: Scrolls through the first level of options, or exits from the current menu or

DOWN

ENTER

function

<UP>: Navigates upward through the menu list or increases the numeric value when in a function

<DOWN>: Navigates downward through the menu list or decreases the numeric value when in a function

<ENTER>: Enables the currently displayed menu or sets the currently selected value in to the current function