Tools Required - Whittier Wood Products 240W Instrucciones Para Armar

240W Wide Alder Upper 2-Door Kit, 241W Wide Glass
Upper 2-Door Kit & 242W Wide Alder Tall Upper 2-Door Kit
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Head Screwdriver, Scissors or Knife.
O — Glass Retainer
FOR 241W ONLY:
1. The Glass Door Frames (A) come with the Glass (N) in place for security during shipping. It
is held in place by small pieces of retainer which should be removed with the glass prior to
finishing the doors.
Place the Glass Door Frames (A) on a clean protected surface and insert the Door Glass (N)
in the notch. Cut the Glass Retainer (O) into eight pieces equal to the length and width of the
glass for both doors. Lay glass retainer pieces flat on the glass and press notched edge into
the door frame along the glass. NOTE: Cutting the Retainer at a 45-degree angle will give
a more finished look.
CAUTION: DO NOT LEAN ON THE GLASS WHEN WORKING ON THE DOOR.
2. Use the compatibility chart below to determine location of the doors you wish to hang on
your hutch.
Door Kit
240W
or
241W
242W
o
FIG. 1
236W Wide 4-Shelf
Hutch
USE WITH
237W Wide 6-Shelf
Hutch
236W Wide 4-Shelf
Hutch
USE WITH
237W Wide 6-Shelf
Hutch
Hinge Plate Location
Hutch
Use predrilled holes in top
and bottom locations.
Use predrilled holes in top
and center locations.
Cannot be used
together.
Use predrilled holes in top
and bottom locations.
Scissors or Knife
FIG. 1A
240W, 241W, 242W – Page 3