Whittier Wood Products 240W Instrucciones Para Armar página 6

Hinge
Arm
B
2
FIG. 8A
8. To attach the doors to the unit, slide the hinge arms (G) onto the Hinge Plates (B) as shown in
FIGURE 8A. Tighten the screw marked '2' in FIGURE 8A to fasten the hinge. The door may
need to be adjusted so that all the spaces between the door and the unit sides are equal. To
adjust, follow instructions in FIGURE 8B.
K
x 2
9. Attach a Pad (K) to the back of each door where it comes in contact with the bottom fixed
shelf.
IMPORTANT:
10. When installing any door kit to a hutch unit, you must install a Furniture Tipping Restraint.
This hardware can be found in the hutch's hardware kit. Follow all directions for proper
installation.
Page 6 – 240W, 241W, 242W
DOOR (A)
3
G
2
FIG. 8B
3
1
Side adjustment 4mm (5/32")
To move the door towards the side
panel, loosen screw '1' and tighten
screw '2'. To move the door away
from the side panel, loosen screw '2'
and tighten screw '1'
Depth Adjustment 4mm (5/32")
Loosen screw '2' (Just one turn),
adjust door to desired position,
re-tighten screw.
Height Adjustment 4mm (5/32")
Loosen screw '3', adjust door to
desired position, re-tighten screw.