Haier HTWR08XCK Manual De Uso Y Cuidado página 5

Mounting tabs can be bent or cut off if not needed.Please use
the correct holes to match the sleeve.
On 26 "-27" sleeves:Use existing rear grille and redirect
3/4
louvers
to 60 angle as shown in Fig.C
5.If the depth of your existing wall sleeve is less than or equal
blocks according to length"A" in the table below.
Depth"D" of the
Length"A"
existing wall
（inches）
sleeve(inches)
5 8
20<D<20
5 8 3 4
20 <D<21
3 4
21 <D<24
6.Remove the backing from the support blocks and attach
them to the inside of the wall sleeve as shown FIG E.Slide the
Wall
Sleeve
Wall
Fig.B
Fig.C
A
3 4
A
3 4
1-
4
Fig.D
Tapered Spacer
Block Board
Tapered Spacer
Block
Fig.E
7.Install the new unit into the wall sleeve.
8.Install the 1"x1 "x84"long stuffer seal between the wall
1/2
sleeve and the unit.
9.To assemble trim,snap the tab of each piece into the slot of
the other piece as shown below.2-Trim frames are supplied
with sleeve as shown below.
Assemble Trim
Note:Be sure to route the cord through the trim frame before
placing the trim frame on the unit.
Fig.F
5