Air Conditioner Use; Important; Starting Your Air Conditioner; Fan Speed - Haier HTWR08XCK Manual De Uso Y Cuidado

Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.

IMPORTANT:

If you turn off the air conditioner, wait at least 3 minutes before
turning it back on. This keeps the air conditioner from blowing a
fuse or tripping a circuit breaker.
MODE SPEED TIMER
ON
FAN HIGH
COOL MED OFF
ENERGY LOW
SAVER
DEHUM
2. Press POWER to turn on the air conditioner. The Power
indicator light will turn on.
NOTE: When the air conditioner is plugged in, the LED display will
show "88" for 3 seconds. After the air conditioner is turned on for
and the fan is set to Low speed.
After the unit is plugged in, but before the unit is turned
on, press and hold the POWER button for 5 seconds to
switch the temperature display between Fahrenheit (F)
and Celsius(C) degrees.
3. Select mode. See "Mode."
4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."
Mode
1. Press MODE until you see the indicator light glow for the
desired setting.
2. Choose Fan, Cool, Energy Saver or Dehum.
Fan—Only the fan runs. Press SPEED to select High, Med
or Low fan speed. The display shows the current room
temperature.
Cool—Cools the room. Press SPEED to select High, Med or
Low fan speed. Press the TEMP/TIME up or down
arrow button to adjust the temperature.
6

AIR CONDITIONER USE

Starting Your Air Conditioner

RESET TEMP/TIME
CHECK
FILTER
POWER
ON/OFF
POWER
ON/OFF
Do not try to operate your air conditioner in the Cool mode when
outside temperature is below 61°F (16°C). The inside evaporator
coil will freeze up, and the air conditioner will not operate
properly.
Energy Saver—Fan runs only when cooling is needed. Press
SPEED to select High, Med or Low fan speed.
Because the fan does not circulate the room air continuously,
less energy is used, but the room air is not circulated as often.
Dehum—Dries the room. The air conditioner automatically
selects the temperature.
NOTE:
Dehum mode should not be used to cool the room.
In Dehum mode,Please do not operate the speed button.
MODE
FAN
COOL
ENERGY
SAVER
DEHUM

Fan Speed

1. Press FAN SPEED until you see the indicator light glow for
the desired setting.
2. Choose High, Med or Low.
SPEED
HIGH
MED
LOW