Urrea 2469 Manual De Usuario Y Garantía página 8

E N G L I S H
• The press is delivered palletized or packaged.
If using either a transpallet or a crane to
move the structure, ensure that the press is
balanced to prevent tipping.
• Unpackage and place the legs as shown in
sketch 3 to place the press on a firm, regular
and horizontal surface.
• Ensure that the work area is sufficiently lit.
• We recommend leaving at least enough
space around the press so that the different
storage and maintenance compartments
8
may be completely opened to accommodate
material pieces of greatest size.
• The press is stable enough to work without
being anchored, but if located in an area of
movement (cranes, wheelbarrows, etc.).
IMPORTANT: IT IS ADVISABLE TO ANCHOR IT.
• Always place the 2 axles (4 axles for the
50t model with fixed cylinder)in a position
appropriate for the operation to be
performed.
IMPORTANT: ENSURE THAT THE TABLE IS
FIRMLY RESTING ON THE AXLES. ESPECIALLY
FOR PRESSES WITH A WINCH.
• Screw the lever in the pump.
OPERATION
1. Place the wedge on the press table, then
attach the work piece on the wedge.
2. Close the release valve by turning it to the
right until it is firmly closed.
3. Activate the pump
approaches the piece.
4. Align the piece and the piston so that the
piece is properly centered.
5. Activate the pump to apply pressure to the
piece.
6. When the work is finished, stop the pump
and open the release valve by turning it to
the left so as to remove the piece.
7. When the work is finished, stop the pump
and open the release valve by turning it to
the left so as to remove the piece.
MAINTENANCE
1. Lubricate the axes and moving parts at
regular intervals.
2. The elements of the press should be kept
clean and protected from aggressive
conditions at all times.
3. Always use original spare parts.
4. Check the oil level of the pump with the
piston of the cylinder fully retracted and
refill as required in accordance with the
volume indicated in the table. To perform
this operation, you must first release the
side cover of the press that allows us to
until the piston