Assembling The Plastic Profiles On The Posts; Assembling The Bottom Rails - Trigano Jardin 880109 Instrucciones De Montaje Y Guía De Utilización

6. Assembling the plastic profiles on the posts

Before starting to assemble the posts themselves, assemble the plastic profiles on to the posts.

7. Assembling the bottom rails

If the pool is not installed on a concrete slab, place a concrete plate approximately 30 x 30 x 5 cm in size at each connecting
point of the bottom rails. These plates must be placed in such a way that their surface arrives exactly at ground level.
WARNING: The entire length of the connecting plate must be laid flat over the flat surface. Using a slab that is too short,
or the absence of a slab, could make installation inadequate or cause the swimming pool to collapse.
Before assembling the bottom rails of the swimming pool, place the lining inside the pool enclosure.
VARUNA-SAPHIR-CANYON Round
2363
2366
1212 / 1615 / 1618
Rail
Sand
Slab 30 x 30 x 5
8803XX
Plastic profile
Follow the same
procedure for the posts
on the straight part
2268
Connecting plate
Slide the rails into the connecting
plates leaving a space of around 1
cm
cm between the rails at the centre
of the connecting plate.
66
Pool interior
Pool exterior
Guide 880109-rev A