Palmer FAB5 Manual De Usuario página 11

6
Power /OFF
The mains switch of the FAB5. It turns the amplifier on (POWER) and off
(OFF).
CONNECTOR PANEL (REAR)
7
7
IEC POWER SOCKET WITH FUSE HOLDER
Connect the included Euro power cord for powering the FAB5 here. The fuse
holder is built into the IEC socket. Always replace burnt out mains fuses
with the correct 250V type as specified under the socket (T800mAL for
230V mains current, T1.25AL for 120V).
8
MAINS VOLTAGE SELECTOR
Make certain that the voltage selection switch is set to the available
mains voltage.
9
EXTERNAL SPEAKER (8
You can use this socket to connect external speaker cabinets; the total
impedance of the connected speakers must be 8 ohms. Depending on the de-
sign and configuration of the cabinet, this enables you to attain higher
volume levels, more punch, and various colourations of tone. The built-in
10" Eminence Ragin Cajun speaker is then automatically deactivated.
10
POWER ATTENUATOR
As a special feature, the FAB5 has a power attenuator with three switch-
able levels that reduce the amplifier with its full output ("Full" posi-
tion – full 5 Watts)to living room ("Room" position – approx 2 Watts) or
bedroom ("Bedroom" position – approx 0.005 Watts)levels. This lets you
enjoy the harmonious output stage distortion of the FAB5 even late at
night without complaints from your neighbours.
11
BOOST
You can use this socket to connect a standard footswitch that lets you
activate or deactivate the BOOST function (see 4).
8 9 10
Ω
)
11
11