Power Options; Setting Slider Tabs - Honeywell Home T4 Pro Serie Instrucciones Para La Instalación

Termostato programable
Ocultar thumbs Ver también para T4 Pro Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Power options

A
S
L/A
S
O/B
Y
W
AUX
2
Y
2
E
G
W
C
K
U
R
U
Rc

Setting Slider Tabs

Set R Slider Tab.
• Use built-in jumper (R Slider Tab)
to differentiate between one or two
transformer systems.
• If there is only one R wire, and it is
connected to the R, Rc, or RH terminal, set
the slider to the up position (1 wire).
• If there is one wire connected to the R
terminal and one wire connected to the Rc
terminal, set the slider to the down position
(2 wires).
NOTE: Slider Tabs for U terminals should be
left in place for T4 Pro models.
UWP Wiring terminal designations
S
Not used for T4
thermostat.
S
Compressor contactor
Y
(stage 1)
Not used for T4
Y2
thermostat.
G
Fan
24VAC common. For 2
transformer systems,
C
use common wire from
cooling transformer.
U
Not used for T4
thermostat.
U
* Terminal can be jumped using Slider Tab. See "Setting Slider Tabs" above.
** The THP9045A1098 C-wire adaptor is used on heat/cool systems when you only have four wires at the
thermostat, and you need a fifth wire for a common wire. Use the K terminal in place of the Y and G terminals on
conventional or heat pump systems to provide control of the fan and the compressor through a single wire—the
unused wire then becomes your common wire. See THP9045 instructions for more information.
Insert R and C wires into
designated terminals
for primary AC power (C
terminal is optional if
batteries are installed,
but it is recommended).
Remove wires by
depressing the terminal
tabs.
L/A
- A
O/B
AUX -
W2
E
W
K
R
Rc
Not used for T4 thermostat.
Changeover valve
Auxiliary heat (TH4210U
only)
Emergency heat (TH4210U
only)
Heat (stage 1)
Connect to K on C-wire
adaptor**
24VAC power from heating
transformer*
24VAC power from cooling
transformer*
3
Insert AA
batteries for
primary or
backup power.
UWP Mounting System
R/Rc Slider Tab
(built-in jumper)
Note: Not all
terminals may be
used, depending
on the system
type that is being
wired. The most
commonly used
terminals are
shaded.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Th4110u2005Th4210u2002

Tabla de contenido