Displaying An Unknown Signal - Rohde & Schwarz RTH Manual De Instrucciones

®
R&S Scope Rider RTH
Key Press shortly
SIGNAL OFF switches off the focused wave-
form.
RUN STOP starts and stops the acquisition.
SETUP opens or closes the "Trigger" dialog to select the trigger type and
adjust the trigger settings.
LEVEL activates the trigger level to be set using the wheel. If the trigger type
has two trigger levels, pressing the key toggles the upper and lower levels.
ACQUIRE opens or closes the "Acquire" dialog to adjust the acquisition
mode.
POWER key: switches the power on or off
4.4

Displaying an Unknown Signal

The R&S RTH can display unknown, complex signals automatically. The
AUTOSET function analyzes the enabled channel signals, and adjusts the hori-
zontal, vertical, and trigger settings to display stable waveforms.
1. Press the PRESET key.
PRESET sets the instrument to a default factory state. The previous user-
defined configuration is removed and all channels except for channel 1 are
disabled.
2. Press the AUTOSET key.
The waveform is displayed.
Getting Started 1326.1561.02 ─ 05
Operating the Instrument
Displaying an Unknown Signal
Press and hold
38