Hayward AquaRite + Manual Del Usuario página 36

A ssigning speeds
Whatever the filtration mode (Manual, Automatic, Smart, Heating or Intelligent), one of the three operating speeds (V1, V2 or
V3) can be selected, thus providing a high degree of flexibility for setting and adjusting the water flow according to the equipment.
The device will first have to be configured to take the variable-speed pump into account (see the section entitled "Setting the pump
type").
The speed assigned to the "antifreeze" mode is V2.
Note: We should point out that the speed of all pool devices requiring a minimum water flow that is appropriate to their correct
operation must be set manually before being stored in the memory and used by the AquaRite + (heat pump, chlorinator, etc.). See
the variable-speed pump instructions for setting all the parameters related to its operation and safety.
Connecting the Wifi option (Optional)
The Wifi module must be installed in the equipment room (dry, temperate, ventilated) and located within reach of the wireless
network cover to which it will be connected. Switch off the device before connecting the module.
Plug the Wifi module connector into the RF / WIFI connector on the AquaRite + card.
Installing the screen wall-mounting kit (not supplied)
Remove the screen from the box and unplug it.
Plug the extension connector into the DISPLAY connector on the AquaRite + card.
Plug the other end of the extension into the screen after first passing the cable through the wall bracket.
Fit the cover (supplied) over the front of the AquaRite + to replace the screen.
USE ONLY GENUINE REPLACEMENT PARTS
Page 12 of 23 AquaRite + Rev. E