Waring Commercial WWB3G Serie Manual De Instrucciones página 4

Features & Benefits
• Hot water dispenser must be plumbed into a water connection.
• Night Mode feature conserves energy and ensures hot water
is ready when you need it.
• Fill rate: approximately 1 gallon per minute when unit is
plumbed-in.
• Initial heat-up time to full capacity: approximately 1.75 hours
(assuming water is at 50°F (10°C) to start)
• Temperature range from 150˚F–205˚F (65˚C – 96˚C)
• Hot water dispenser will maintain set water temperature
within +/- 5°F
• Safety Features (Low and High level sensors)
• Tomlinson
• Excess water drain: Easily and safely removes excess water
from below spigot level.
• Low water level sensor: In case water level gets low, an
alarm will sound and the heater will automatically be shut off.
This protects your machine. Once the issue is corrected/more
water added, the alarm will stop
• High-level water sensor: If water level gets too high, an alarm
will sound and the heater will automatically be shut off
• Left and right cup-warming guards
• Removable drip tray for easy and convenient cleaning
GROUNDING INSTRUCTIONS
For your protection, the Waring
is equipped with a 3-conductor cord set that has a molded 3-prong
grounding-type plug, and should be used in combination with a
properly connected grounding-type outlet, as shown in Figure 1.
If a grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained so that a 2-slot wall outlet can be used
with a 3-prong plug. Referring to Figure 3, the adapter must be
grounded by attaching its grounding lug under the screw of the
outlet cover plate.
CAUTION: Before using an adapter, it must be determined that the
outlet cover plate screw is properly grounded. If in doubt, consult a
* Tomlinson , No-Drip and the Faucet and Handle configurations are registered trademarks of The Meyer Company, Cleveland, Ohio.
® ®
No-Drip tap operation*
® ®
Commercial Hot Water Dispenser
TM
4