Kicker ZXM.2 Serie Manual Del Propietário página 2

Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
PERFORMANCE
Model:
RMS Power, all channels driven
@ 14.4V, 4Ω stereo,  1% THD+N
@ 14.4V, 2Ω stereo,  1% THD+N
@ 14.4V, 4Ω mono,  1% THD+N
Length
Specifi cations common to all models:
Height
Width
Frequency Response ± 1dB
Signal-to-noise Ratio
Input Sensitivity
Selectable Electronic Crossover
Bass Boost
Pro Tip: To get the best performance from your new KICKER Amplifi er, use genuine KICKER accessories and
wiring.
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4" (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64" (3mm) bit and use the supplied #8 screws to mount the amplifi er.
Wiring: Disconnect the vehicle's battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er.
The ZXM amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level
signals from your car stereo's source unit. Ideally, when connecting the source unit to the amplifi er, the ZXM
amplifi er's input level switch should be set to "LO" and a low-level signal should run from the source unit's
stereo RCA output to the stereo RCA input on the end panel of the amplifi er using RCA interconnect cable. If a
low-level stereo RCA output is not available on the source unit, the signal can be delivered to the amplifi er using
the high-level speaker outputs on the source unit. Set the input level switch on the end panel of the amplifi er
to "HI". Crimp and solder RCA connectors to the end of the speaker wire running from the high-level speaker
outputs on the source unit and connect the wire to the RCA Inputs on the end panel of the amplifi er or simplify
the installation by using a KICKER ZISL as shown below. Either input method will provide a low-level output signal
2
2010 ZXM 450.2 RevC.indd 2 2010 ZXM 450.2 RevC.indd 2
All manuals and user guides at all-guides.com
ZXM.2-SERIES AMPLIFIERS Owner's Manual
ZXM450.2
ZXM450.2
150W x 2
225W x 2
450W x 1
16¾" (425mm)
2-1/8" (54mm)
9-5/8" (244mm)
20Hz–20kHz
>95dB, A-weighted, re: rated power
Low Level: 125mV–5V
High Level: 250mV–10V
Variable HI, LO, or OFF (bypass) | 50–200Hz, 12dB/octave
Variable 0–18dB @ 40Hz
ZXM AMPLIFIERS
10/29/2009 12:58:33 PM 10/29/2009 12:58:33 PM