Feed Water Supply
Check and comply with local plumbing codes as you plan,
then install a cold feed water supply fitting. For new home installation using
standard plumbing fittings, see first two illustrations below. A typical
installation for existing homes using the saddle valve is shown in third
illustration below.
A. PREFERRED INSTALLATION
1
Turn off the cold water supply.
2
Complying with plumbing codes, install a fitting on the cold water pipe to
adapt 3 ⁄ 8 " OD tubing. A typical connection is shown in illustrations at right
(parts not included). Make sure a water supply valve is used.
Typical location
B. OPTIONAL HOME INSTALLATION Where codes permit
*For 1/2" OD or larger metal tubing only.
NOTE: Codes in the state of Massachusetts require installation by a licensed
plumber and do not permit the use of the saddle valve. For installation,
use plumbing code 248-CMR of the Commonwealth of Massachusetts.
Turn off the cold water supply and attach saddle valve as shown in
1
illustration at right.
DANGER: To protect yourself from serious injury or fatal shock, use
a battery-powered hand drill only to make the hole. DO NOT USE AN
ELECTRIC DRILL.
Close the water supply valve by turning the handle clockwise.
2
Open the main water supply valve and several house faucets to purge
3
air from the system. Close faucets when water runs smoothly.
Some threads
should be visible
support@fridgefilters.com
Cold
water
Snug valve into bracket
DO NOT OVERTIGHTEN
Rubber gasket
800-683-8353
support@fridgefilters.com
Preferred water supply connection
(using compression fitting)
Cold
water
pipe
3⁄8" tubing to inlet
Optional water supply connection (using saddle valve)*
*For 1/2" OD or larger metal tubing only.
Nut (2)—not
required if holes
Pre-drill
in clamp are
1⁄4" hole
threaded
Clamp Z
Washer
Tubing adapter
Compression nut
Use to connect the tubing
800-683-8353
Water supply valve
Insert (not included)
Ferrule
Seal—make sure the
seal is in place
Clamp X
Valve
Handle
5
www.FridgeFilters.com