Urrea CN1108A Manual De Usuario Y Garantía página 25

cutterhead pulley until one of the knives is at
top-dead-center (TDC) (Figure 27).
Fig. 27
Top Dead
Center
4. When correctly set, the knife will just touch
the straightedge when the knife is at its high-
est point of rotation (Figure 28), and the
straightedge should move 5/32" toward the
infeed table when the cutterhead pulley is ro-
tated.
Fig. 28
· If your outfeed table is correctly set, no ad-
justments are necessary.
· If the knife lifts the straightedge off the table
or the table is below the straightedge, loosen
the outfeed table lock, and adjust the outfeed
table height with the hand wheel until the
straightedge just touches a knife at its highest
point of rotation.
5. Lock the outfeed table, reinstall the cutter-
head guard, and close the rear access panel.
DEPTH STOP KNOB
A depth stop knob
(Figure 29) on the
depth scale assembly
allows the operator
to set the maximum
depth of cut to 1/8".
To engage the knob, adjust the table height to
1/8" until the knob clicks into place. To disen-
gage the knob, pull it out and adjust the table
to the desired height.
SETTING FENCE STOPS
The fence stops simplify the task of adjusting
the fence to 45˚ inward, 90˚, and 45˚ outward
(135˚).
Fig. 29
E N G L I S H •
1. Using a 45˚ square,
adjust the fence to the
45˚ inward position, as
shown in Figure 73.
2. Loosen the jam nut
shown in Figure 74.
3. Adjust the 45˚ in-
ward fence stop bolt
until it makes contact
with the back of the
fence bracket.
4. Retighten the jam
nut loosened in step 2.
TO SET THE 90˚ FENCE STOP
1. Using a 90˚ square,
adjust the fence to the
90˚ position, as shown
in Figure 75.
2. Push the plunger in.
3. Loosen the jam nut
on the 90˚ fence stop
bolt (Figure 76).
4. Adjust the 90˚
fence stop bolt until
it makes contact with
the 90˚ plunger knob
shaft.
5. Retighten the jam nut loosened in Step 3.
TO SET THE 45˚ OUTWARD FENCE STOP
1. Pull the plunger out
(see Figure 76 on Page
41).
2. Using a sliding bev-
el adjusted to 135˚,
adjust the fence to
the 135˚ (45˚ outward)
position, as shown in
Figure 77.
3. Loosen the jam nut
on the 45˚ outward
fence stop bolt (Fig-
ure 78).
4. Adjust the 45˚ out-
ward fence stop bolt
until it makes contact
with the back of the
fence.
5. Retighten the jam nut loosened in Step 3.
U ser 's manual
Fig. 30
Fig. 31
Fig. 32
Fig. 33
Fig. 34
Fig. 35
25