Danby DDR050BJPWDB Manual Del Propietário página 7

OPERATING INSTRUCTIONS
WATER REMOVAL
2. Continuous Drain
Water can be removed from the appliance using the
continuous drain connector and the provided drain
hose.
Before using any automatic drain functions,
check that all drain ports are clean and free of
debris. There is one drain port inside the bucket
compartment of the appliance, remove the bucket
to see it. There is one drain port on the back of the
appliance where the drain hose attaches. All drain
ports should be cleaned with a pipe cleaner prior to
use.
Note: Do not clean the drain ports with anything
more rigid than a pipe cleaner as this can damage
the appliance.
Note: If the drain ports are clogged or dirty it
can cause water to leak from the bottom of the
appliance.
Remove the cover from the continuous drain outlet
and attach the provided drain connector that
is shipped inside the water bucket. Attach the
provided drain hose to the drain connector and
direct the other end of the drain hose to a bucket or
fl oor drain.
Ensure that the drain hose is not bent and goes
straight down from the back of the appliance. The
continuous drain is only activated by gravity so any
bends or upward motion in the hose will stop the
water from draining.
The drain hose is 2 m (6.6 feet) long. Do not
connect this drain hose together with any other
hose. If the drain hose is too long water may not
drain completely which can lead to stagnant water
and mildew build up inside the hose.
Note: When the ambient temperature is higher than
the temperature of the water inside the drain hose,
condensation may appear on the outside of the
drain hose. This is normal.
WATER REMOVAL
3. Pump Drain
If the continuous drain is inconvenient, water can be
removed from the appliance using the pump drain.
When using the pump, the appliance will fi rst fi ll the
bucket with water and then the pump arm will pump
water from the bucket through the drain and out the
hose.
Remove the cover from the pump drain outlet and
attach the provided drain hose. Direct the other end
of the hose to a drain. Press the pump button to
activate the pump function. When the bucket is full,
the pump will begin to work.
Ensure that the drain hose is not bent, this can stop
the water from draining correctly and overwork the
pump.
Do not connect the provided hose together with
another hose. The maximum length of the pump
drain hose should be no more than 4.6 m (15 feet).
If the drain hose is too long water may not drain
completely which can lead to stagnant water and
mildew build up inside the hose.
When using the pump drain, the water bucket
should be emptied every few days to ensure that the
water in the bucket does not become stagnant or
grow mildew.
6