Makita DGA405 Manual De Instrucciones página 7

FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
2
015306
CAUTION:
Always switch off the tool before installing or
•
removing of the battery cartridge.
Hold the tool and the battery cartridge firmly when
•
installing or removing battery cartridge. Failure to
hold the tool and the battery cartridge firmly may cause
them to slip off your hands and result in damage to the
tool and battery cartridge and a personal injury.
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge fully until the
•
red indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
Do not install the battery cartridge forcibly. If the cartridge
•
does not slide in easily, it is not being inserted correctly.
Indicating the remaining battery capacity
(Only for battery cartridges with "B" at the end of the
model number.)
2
015676
1. Button
2. Red indicator
3. Battery
cartridge
3
1. Indicator lamps
2. CHECK button
1
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator lamps
Lighted Off
015658
NOTE:
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
Switch action
CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the switch lever actuates
properly and returns to the "OFF" position when
released.
Do not pull the switch lever hard without pulling
•
the lock-off lever. This can cause switch breakage.
1
015307
To prevent the switch lever from being accidentally
pulled, a lock-off lever is provided. To start the tool, pull
the lock-off lever toward the operator and then pull the
switch lever. Release the switch lever to stop.
Accidental re-start preventive function
Even if installing the battery cartridge while pulling the
switch lever, the tool does not start.
To start the tool, first release the switch lever. Then pull
the lock-off lever and then pull the switch lever.
7
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1. Lock-off lever
2. Switch lever
2