Publicidad
Idiomas disponibles
Idiomas disponibles
Fit the bolts (14) and flat washers, as
shown in Fig.5, align the handlebar
stem and hand tighten.
5. FITTING THE BOTTLE
HOLDER.-
Take the bottle holder (89), insert it in
through the top of the handlebar (13),
Fig.6.
Next, release the screws (91) on the
handlebar (13), position the bottle
holder and secure it by using the
screws (91) removed previously.
6. INSTRUCTIONS FOR
FITTING THE SADDLE
In order to raise or lower the saddle
post (39), Fig.7, first loosen off the
control knob (41) on the saddle post a
little by turning it in an anticlockwise
direction.
Pull the control knob back and without
releasing it, move the saddle post up or
down. Next, take the horizontal tube for
the saddle (34) and attach the saddle
(33) to it, Fig.9, tighten the nuts (Z).
VERTICAL ADJUSTMENT.
In order to raise or lower the saddle
post, first loosen off the control knob
(41) on the saddle post a little by
turning it in an anticlockwise direction,
pull the control knob back and without
releasing it, move the saddle post up
or down, Fig.7. When it is at the right
height release the knob and it will lock
into a hole on the saddle post. Tighten
it up by turning the control knob (41) in
a clockwise direction.
HORIZONTAL ADJUSTMENT.
To adjust the saddle's horizontal
position, loosen the control knob (37)
on the saddle's horizontal bar and
move the saddle, along with the bar,
into the desired position, then tighten
the control knob securely, Fig.7.
TILTING THE SADDLE.
The saddle can be tilted backward or
forward. Loosen off nut (Z) shown in
Fig.7, located under the saddle, tilt the
saddle into the desired position and
then retighten the nut securely.
Do not adjust the tilt of the saddle
while you are still sitting on it.
7. FITTING THE MONITOR.-
Bring the monitor (2) to the handlebar
stem (13) Fig.8, connect the two
terminals (16 / Q) coming out of the
handlebar stem (13) and the monitor
(2), Fig.8.
Insert
the
handlebar stem (13), as shown in
Fig.8, making sure not to pinch any of
the cables. Fit the bolts (8) along with
the flat washers, making sure that the
handlebar
securely tighten all of the bolts on the
handlebar stem including the bolts at
the base which were left hand tight in
point 4.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This is
achieved by screwing the adjustable
foot (28) up or down, Fig.9.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (23)
to make it easier to move about. The
two wheels at the front of the unit
make it easier to place the unit in any
chosen position, as shown in the
Fig.10.
Store it in a dry place, preferably not
subject to changes in temperature.
11
monitor
(2)
onto
is
aligned
the
correctly,
Publicidad
