Lighting Instructions; Maintenance - Agio WT17ZL Instrucciones De Ensamblado

The flames should look like those in Figure 13. To clean the
burner, use a soft brush after the burner has cooled
completely. Never use a vacuum cleaner on the burner. It is
recommended to store the fire pit indoors during winter if it
will be subjected to freezing temperatures. The LP cylinder
must be disconnected and removed from the appliance
before the appliance can be stored indoors.
Warning: If these instructions are not followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
1. Open the tank drawer and find the control panel on the left. Make sure the control knob is in
the "OFF" position. See Figure 14. Open the tank valve all the way.
IGNITER BUTTON
2. Push in the igniter button. You will hear a slight clicking sound. With the igniter button
pushed in, push and turn the control knob to the "ON" position. The fire should light within a
few seconds. Once the flame is lit, release the igniter button and continue to hold the control
knob in for 10 to 15 seconds. Release the control knob. The control knob should pop back out
and then the fire remain lit. Note: If the fire does not light, turn the knob to the "OFF" position
and wait five (5) minutes before trying again.
3. To turn down the flame, push the control knob in slightly and turn to Medium (medium
flame), or Low (small flame).
4. To shut down the fire pit, turn the control knob to the "OFF" position and turn off the tank
valve.

MAINTENANCE

LIGHTING INSTRUCTIONS

Figure 14
12
Figure 13
CONTROL KNOB