Tabla de contenido
Publicidad
FIGURE 1.
MOUNTING AND WIRING INSTRUCTIONS
GB
NOTE: Line art shown may not exactly match the fixture enclosed. However, the installation
instructions do apply to this fixture.
1. Turn off power at circuit box to avoid possible electric shock.
2. Place mounting bar (B) flush against wall at desired mounting location. Using outside
mounting bar holes as a guide, mark where pilot holes are to be drilled.
NOTE: Mounting bar must be straight for fixture hanging straight.
3. Inset two plastic anchors (G) into the pilot holes (for drywall).
4. Align outside mounting bar holes with plastic anchors (G) (If applicable). Secure mounting
bar (B) into place using wood screws (E).
5. Make an electrical connection by loosening the terminal screws on the terminal block (M)
and inserting the live, neutral and ground terminals.
6. Tighten terminal screws. Make sure there are no stray wires.
7. Position back plate (C) over mounting screws (A) by aligning back plate openings (F) with
mounting screws (A).
8. Secure with cap nuts (H).
9. Install glass shade (L) and plate (P) (if applicable) into holder(s) (N). Secure with thumb screws
or ring(s) (O), whichever is applicable.
10. Install lamp (not supplied). (Please do not exceed the maximum capacity recommended on
the socket).
11. Turn power back on at circuit box.
GS-26-XL06-WH19
B
G
M
L
N
A
E
C
F
O
P
L
N
H
11
Publicidad
Tabla de contenido
