Publicidad
Idiomas disponibles
Idiomas disponibles
How to use these instructions
All of the necessary diagrams can be found on
the first pages of this set of instructions. Within
the descriptions, you will be directed by cross-
references to the appropriate diagrams.
Before you begin...
Intended use
When used for its intended purpose, this
device corresponds to the state of the art, as
well as to the current safety requirements at
the time of its introduction.
The product permits two operating modes:
When used as a crosscut and mitre saw, it is
intended for cross cuts, mitred cuts, inclined
cuts and double mitre cuts in elongated
workpieces such as profiles and strips
When used as a circular bench saw, it is
intended for long and cross cutting of solid
wood, laminated wood, chipboard, wood-
core plywood and similar wood materials.
Round workpieces may only be sawed using a
suitable clamping system, otherwise they can
be twisted by the rotating saw blade.
Only materials for which the concerned saw
blade is approved can be processed.
The device is not suitable for commercial or
industrial use.
Any other type of use is inappropriate.
Improper use or modifications to the device or
the use of components that are not tested and
approved by the manufacturer may result in
unforeseen damage!
Any use that deviates from its intended use
and is not included in these instructions is
considered unauthorised use and relieves the
manufacturer from his or her legal liability.
Your product at a glance
Crosscut sawing function
• P. 3, item 1
2. Handwheel for incline adjustment
3. Tool arm
4. Saw blade
5. Reciprocating protective hood
6. Workpiece stop
7. Saw table
• P. 4, item 2
8. Release lever for saw bench
9. Clamping fixture
10. On-Off switch
11. Release button for tool arm
12. Safety bolt
13. Swarf remover
14. Locking screw for incline adjustment
Circular bench saw function
• P. 4, item 2
15. Cross stop
16. Splitting wedge
17. Swarf cover
18. Parallel stop
19. Handwheel for incline adjustment
20. Locking screw for incline adjustment
21. Hand crank for cutting height adjustment
22. On-Off switch
Scope of supply
• Mounting saw
• Cross stop
• Parallel stop
• Hand crank for cutting height adjustment
• Protective box
• Slide rod
9
• Dust bag
• Allen key (3×)
• Swarf cover
• Instructions for use
Publicidad
