Warranty; Maintenance Jobs For The End User; Air Bleeding; Maintenance Reserved To A Professionally Qualified Engineer - Cattini Oleopneumatica YAK 218/N Manual Uso Y Mantenimiento

EN
Improper use
The air-hydraulic jack has been designed and made to lift transport vehicles. Any other use of the jack, such as for
instance lifting and/or moving persons, is considered to be definitely improper. All use of the jack not in conformity with
the safety rules listed in this manual is considered to be improper use.

WARRANTY

This jack is covered by a 12-month warranty starting from the date the warranty comes into effect or from the date the
jack leaves our factory if it has not already been rendered effective on-line; it covers all manufacturing defects but not
transport expenses, defects caused by improper use or damages suffered during transport. For more details please see
the card attached to this manual.

MAINTENANCE JOBS FOR THE END USER

- To ensure your jack a long life it is advisable to clean the pistons externally once a fortnight.
- Check the level of oil in the tank at least twice a year: this must be done with the pistons completely
lowered. The oil level must be up to the small bolt that is on the side of the cylinder/tank, you can check by loosening it.
If you have to top up the oil in the tank make certain the oil you are using is compatible with what is already inside the
tank so as not to compromise machine integrity. DWG. 15
- If the oil level is higher than it should be, even by only a little, or if the jack has been turned up- side down (as can easily
happen during transport), the oil is expelled through the suction pump as mist. This phenomenon disappears on Its own
when the oil level hase been restored. If the oil inside the tank exceeds the level by a lot, it is advisable to remove some
until it is back in the norm.

AIR BLEEDING

Each time the jack is serviced, removing and refitting parts connected to the tank and motorpump, it is advisable to bleed
off all air.
1. The piston must be moved out completely.
2. Loosen (NEVER unscrew the dowel completely!) dowel no. 2534 which is in the housing of the extension on
the plate, and let all the air out from the dowel, continuing until oil starts coming out and then close the dowel. DWG.
16
3. Move the piston back in completely and check the oil level.
4. Try to operate the jack without any load and if the piston lowers in jerks repeat the procedure at least 2 or 3 times.
MAINTENANCE RESERVED TO A PROFESSIONALLY QUALIFIED
ENGINEER
Having to carry out maintenance or overhauling, use exclusively genuine spare parts to ensure the utmost reliability for
the jack.
PROBLEMS
Solutions
16