Operation Modes; Function Description; Turning Off The Appliance; Timer Function - UFESA DH4012 Manual De Instrucciones

OPERATION MODES

Normal Operation Mode
It is possible to set the humidity level in a range from
85% to 35% RH (relative humidity) with value skip of 5%.
1
Set the desired air humidity by pressing the "–" (C)
or "+" (D) button.
The selected humidity value will be saved
within 5 seconds, then the display shows
current level of humidity in the room.
The appliance controls the level of
humidity set. When the set humidity
level is reached, the appliance turns off
automatically and will turns on again when the
level of humidity in the room is different from
the set value by 5%.
If the air humidity is still higher than
desired, set the humidity level to a lower
value or select continuous mode of
operation that provides maximum
dehumidification performance (see section
Continuous Operation Mode).
Continuous Operation Mode
It is possible to run the appliance in a continuous mode
for maximum dehumidification performance, if the
condensate drain tube was connected or until the water
tank is completely full.
1
Press continuo button (A) to enable continuous
room dehumidification mode.
● Press the continuo button again to disable continuous
operation of the appliance.
During the continuous operation of the
appliance it is not possible to set the
desired humidity.

TURNING OFF THE APPLIANCE

1
Press the on/off button (F) to turn off the appliance.
2
Unplug power cord (12) from the wall outlet.
If you need to start the appliance
immediately after it is turned off, wait
three minutes to restart it. In this case,
a safety device delays the start of operation for
3 minutes, in order to protect the dehumidifier.
If the appliance is suddenly turned off
C
due to power failure, it will automatically
start when the power is restored. In this
case, a safety device delays the start of
operation for 3 minutes, in order to protect the
dehumidifier. After 3 minutes the appliance will
automatically restart in accordance with the last
used settings.

Function description

TIMER FUNCTION

When the appliance is not running, you can set the time
after which it will start automatically.
When the appliance is running, you can set the time after
which it will automatically stop.
Enabling the timer function.
1
Press the timer button (B).
2
Use the "+" (D) or "–" (C) button to set the time
in hours (0-24 hours), after which the appliance will
automatically turn on/off.
Time may be changed in increments of
0.5 h to 10 h, and then by 1 h up to 24 h.
D
The selected time will be saved within
5 seconds, then the display shows
current level of humidity in the room.
Disable the timer function
3
Press the timer button (B) to disable the automatic
on/off function.
4
Then press the timer button (B) again or use the
"–" button (C) and set the time to 0.0.
Automatic on/off function will be
cancelled if after being enabled, the user
E
will turn on or off the appliance.
Automatic on/off function will be
cancelled when the display shows P2
warning code.
F