Dörr FSE-1B Manual De Instrucciones página 11

06 | INSTALLATION OF RECEIVER AND SENDER
Receiver
Connect the fl ash cable (2) to the corresponding socket of your studio fl ash. If necessary, use the supplied 6,35mm
adapter.
Sender
Slide the hot shoe of the sender (5) onto the hot shoe of your camera.
If necessary, use the supplied sync cord.
CAUTION:
07 | OPERATION
1. Switch on the connected studio fl ash and set it to the desired power level.
2. Press the On/O button (1) to switch on the receiver.
To check the radio connection, press the test button (7) at the sender.
If the receiver is connected properly the studio fl ash is triggered once.
The receivers LED indicator (3) lights up briefl y in red colour.
3. Turn your camera on and set the desired aperture, exposure time and ISO number.
Please ensure that the exposure time is not shorter than 1/250s, and not shorter than the cameras fl ash sync
time (fl ash sync time, refer to the specifi cations of your camera). It is recommended to use an exposure time
of 1/125s.
4. When you take a picture now, the connected studio fl ash will be triggered at the same time.
Only model FSE-4B (4 channels):
Changing the channels
In case of interfering frequencies from the environment, it is recommended to set a di erent channel at the sen-
ders channel setting (9). There are 4 channels available. The receiver automatically switches to the new channel
when you briefl y switch the receiver o and on again (press the On/O button (1)).
Your camera must be o power.
11