Health O Meter PRO PLUS 2500KL Manual De Operación página 6

ASSEMBLY INSTRUCTIONS
13. Gently return the scale to the upright position.
WARNING: Do not drop the scale on its feet. This could result in load cell damage.
14. Install the AC adapter holder on the inner left side of the handrail using the 2 self-tapping
screws included.
15. Attach 2 cable holder clips to the inner left handrail and one underneath the handrail by
peeling off the paper covers from both sides of the adhesive pad and applying to the
handrail. Firmly press the clips on top of the adhesive to secure.
16. Insert AC adapter into the adapter holder and insert the power cable into the 3 clips on the
left side of the handrail
17. Screw/unscrew the plastic feet to level the scale.
Ramp - Moving Instructions
1. Remove the guardrail at the end of the platform by unscrewing 4 screws. (see Figure 4)
2. Fold the ramp on the platform surface.
3. Gently tip the scale over and place with handrail on the floor.
4. Remove the screws attaching 2 rubber bumpers on the side of the platform under the
ramp attachment. Remove the bumpers. Install the rubber bumpers on the opposite
platform side in the appropriate holes.
5. Loosen 4 screws at each ramp holder (2 screws on the side of the platform, 2 screws
underneath, close to wheel).
6. Remove the ramp from the ramp holders, then release all the screws to the end and
remove ramp holders by pulling out slightly.
7. Install ramp holders in the same way at the opposite side of the platform, do not tighten
screws.
8. Insert the ramp between ramp holders and tighten screws.
9. Install the guardrail by screwing 4 screws. Note: It is necessary to bore a hole in the mat to
insert the screw in appropriate hole beneath the mat.
(refer to the Parts List on page 22 for details on parts followed by
NOTE: A second Ramp is available separately as 2500RAMP.
Figure 4. Ramp Moving
5
#
)