RIB PREMIER 24V Manual Del Usuario página 38

G
B
A - CONTROL PANEL FEATURES
J12 J11 J10
PROG
SENS
RUN
TCA
LOW SP
J1 N F Power supply 230 Vac 50/60 Hz - external to the control panel -
(120 V 60 Hz upon request)
J2 A+TEST + 24Vdc photocells self-test power supply
A- - 24Vdc accessories power supply
A+ COM + 24Vdc accessories power supply
J3 COM A+ Common contacts / Positive 24 Vdc
B.I.O. Contact (NO) dedicated to a clock
PED. Pedestrian opening contact (NO)
START Single pulse contact (NO)
CLOSE Closing impulse contact (NO)
OPEN Opening impulse contact (NO)
J4 COM A+ Common contacts / Positive 24 Vdc
STOP STOP impulse contact (NC)
PHOTO 1 Photocells contact 1 (NC)
PHOTO 2 Photocells contact 2 (NC)
EDGE 1 Edge 1 contact (NC)
EDGE 2 Edge 2 contact (NC)
J5 Radio Antenna 433MHz
R-AUX Auxiliary relay contact (NO) Max 700 W
SIGNAL - Gate open state and battery state output indicator (24 Vdc 3
W max)
LOCK - Electric lock connection (MAX 15W 12V)
24Vdc blinker (code ACG7072) power supply. Pay attention to
the polarity.
COM A+ Common contacts / Positive 24 Vdc
J9 J8
J13 J14
38
J7 J6
J15
J6 RADIO Connector for radio module ACG8069
J7 RADIO Connector for radio receiver RIB, 24 Vdc supply
J8 BATTERY CHARGER Connector for charge card of 24 Vdc battery (code ACG4774)
(24 V DC SOLAR)
J9 SERIAL COM /SYNC Connector for serial connection
J10 APP+ Connector for APP+ card
J11 APP Connector for APP Card
J12 RS485 termination of J10
J13 MOTOR 2 MOTOR 2 CONNECTION (without polarity)
J14 MOTOR 1 MOTOR 1 CONNECTION (without polarity)
J15 SECONDARY Connection to secondary coil of transformer 18 Vac
TRANSFORMER
SENS Trimmer for adjusting sensitivity to impact against an obstacle
TCA Trimmer for automatic closing time adjustment (DISABLED BY
FACTORY AND DL11 LED OFF)
RUN Trimmer for high speed adjustment operations
LOW SP Trimmer for low speed adjustment operations
PROG Programming button
F1 T 2 A Transformer protection fuse (external to the card B2 24V)
F2 T 8 A Motors protection fuse
J2
J3
J5
J4
J1
F2 F1
F
N