Tabla de contenido
Publicidad
EXTRACCIÓN DE CAPOTA Y REJILLA
1. Eleve la capota.
2. Retire el conector del cable del faro.
3. Retire la presilla y la arandela del tornillo de
apoyo derecho.
4. Sitúese frente al tractor. Tome la capota por
los lados y deslícela hacia la izquierda, para
retirarla de los tornillos de apoyo, y elévela
para extraerla del tractor.
5. Al volver a colocar la capota, enchufe otra
vez el conector del cable del faro y reinstale
la arandela y la presilla en el tornillo de apoyo
derecho.
Capota
Tornillo de apoyo
izquierdo
Arandela
Presilla
04031
Tornillo
de apoyo
derecho
Conector del
cable del faro
TRANSMISIÓN
REMOCIÓN/REEMPLAZO DE LA TRANSMISIÓN
Si por acaso su transmisión debe ser removida
para servicio o reemplazo, debe ser purgada
después de la reinstalación y antes de operar el
tractor. Vea "PUR GAR LA TRANSMISIÓN" en la
sección de la Operación de este manual.
MOTOR
PARA AJUSTAR EL CABLE DE CONTROL DE
LA ACELERACIÓN
El control de la aceleración ha sido preajustado en
la fábrica y no debería necesitar ajustes. Revise
los ajustes que se describen a continuación, antes
de soltar el cable. Si el ajuste es necesario, vea
de manual de motor.
62
UNASSEMBLED PARTS
Slope Sheet
Keys
(2) Keys
(1) Oil Drain Tube
ASSEMBLY/PRE-OPERATION
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Stan dard wrench sizes are listed.
(1) 1/2" wrench
Tire pressure gauge
(2) 7/16" wrenches
Utility knife
Pliers
When right or left hand is mentioned in this
man ual, it means when you are in the operating
po si tion (seated be hind the steer ing wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
•
Remove all accessible loose parts and
parts cartons from carton.
•
Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
•
Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
Battery
(2) Hex Bolts
(2) Nut Keps
(1) Quick Connect
CONNECT BATTERY
WARNING: Do not short battery ter-
mi nals by allowing a wrench or any other
object to contact both terminals at the same
time. Before connecting battery, remove
metal bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
prevent sparking from ac ci den tal grounding.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in the Maintenance section of
this manual for charging instructions.)
•
Determine battery location. Battery loca-
tion will be under the seat or the hood.
•
Lift seat pan or hood to raised position.
•
Remove two terminal caps and discard.
•
First connect RED battery cable to
positive (+) terminal with bolt and nut as
shown. Tighten securely. Slide terminal
cover over terminal.
•
Connect BLACK grounding cable to
negative (-) ter mi nal with remaining bolt
and nut. Tighten se cure ly.
•
Lower seat pan or hood.
7
Publicidad
Tabla de contenido
