Troubleshooting - Revell Control Beesting Lion Coobra Manual Del Usuario

4 START PREPARATION
• Set the ON/OFF switch on the remote
control (2C) to the "ON" position (4A).
The power LED (4B) on the remote
control flashes.
• Set the ON/OFF switch on the model
(1B) to the ON position (4C).
The ON/OFF switch on the model and the
remote control must be set to OFF after
use. Otherwise, a drive command can
accidentally be triggered, causing the
vehicle to drive away on its own, which
can lead to considerable damage.
6 VEHICLE CONTROL
6A To drive forwards, pull the lever for forward and reverse travel (2A) with the left
index finger.
6B To drive in reverse, push the lever for forward and reverse travel (2A) forwards
with the left index finger.
6C To drive along a left curve, turn the steering wheel (2D) to the left (top view).
6D To drive along a right curve, turn the steering wheel (2D) to the right.
INSTRUCTIONS FOR SAFE DRIVING
GENERAL DRIVING TIPS:
• Always maintain visual contact with the vehicle and do not look at the remote
control!
• On initial driving attempts, there is a general tendency toward excessive movements
of the controls. Make sure that you have sufficient room.
After a crash, always release the lever for forwards and reverse travel immediately in
order to prevent damage to the electronics.
THE SUITABLE DRIVING ENVIRONMENT:
The location in which the vehicle is driven should fulfill the following criteria:
1. It should be a location in which there is as much open area as possible, without
disruptive obstacles.
2. Make absolutely sure when starting that there are no people or animals in the
immediate vicinity.
3. Always watch the vehicle so that it does not drive into the operator, other people or
animals and injuries them.
12
5 STEERING TRIM ADJUSTMENT
The correct trim is a basic requirement
for fault-free driving behaviour from the
vehicle. Adjusting the trim is easy, but it
requires a little patience and a feel for it.
Please follow the following instructions
precisely:
If the vehicle pulls to the left or right
while driving without steering...
use the trim lever (1E) to correct the wheel
alignment by turning it in the opposite direc-
tion. The trim lever can be found on the un-
derside of the vehicle (cf. 5).

TROUBLESHOOTING

Problem: The vehicle does not move.
Cause:
• The batteries are too weak and/or depleted.
Remedy: • The batteries were possibly not inserted correctly. Please observe the polarity
indication in the model.
• Please replace with new batteries.
Problem: Remote control does not work.
Cause: 1. The batteries were not inserted correctly.
2. The batteries do not have enough power.
Remedy: 1. Check whether the batteries are inserted correctly.
2. Please replace with new batteries.
Problem: The vehicle cannot be controlled with the remote control.
Cause: 1. The batteries are depleted.
2. The connection between the remote control and vehicle has been severed.
Remedy: 1. Insert new batteries.
2. When the model is further than 10 metres away, move towards the model.
Additional tips and trick can be found online at www.revell-control.de.
SERVICE NOTES
Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
13