Hansgrohe Mediano 14912000 Instrucciones De Instalación/Garantía página 6

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the rubber sealing
washer in position on the sink.
3. Slip the slide washer, washer and collar nut over
the threaded base and tighten the collar nut by
hand. Tighten screws.
4. If necessary shorten platic hose according to the
table and insert it up to the collar into the
shorter blue marked copper pipe.
5. Connect the shorter, blue marked supply pipe to
the angle valve.
Connect the longer blue marked pipe to the
inlet and the red marked to the outlet of the
storage tank.
Attention!*
With water heaters of 5 liters the flow rate at the
mixer should not exceed 5 l/min.
In this case the flow rate must be reduced at the
angle valve.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
When the storage tank is being heated, the spout
will drip.
When changing the spray former, it is imperative to
use one made for this type of mixer.
max. permissible water
pressure on the spot
in bars
1 - 1,5
2 - 3
4 - 7
Hose lengths to be used
8, 10 and 15 liters
without hose
hose to be short
If pressure greater than 5 bar, fit pressure reducer.
English
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Rate of flow with water heaters
of 5 liters:
Spare parts
1 handle
1.1 screw cover basin
2 flange
3 nut
4 cartridge cpl.
5 seals
6 service set
7 mixer ball
8 spray former
9 washer
10 fixation cpl.
fixation extension 35 mm
storage tank volume
ened to 90 mm
hose unchanged,
reduce flow rate at the angle valve*
up to 5 liters
hose to be shortened to 90 mm
hose unchanged
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
max. 5 l/min
94186000
95046000
94106000
14097000
13967000
13953000
13966000
94033000
94850000
13961000
13898000