Important Charging Notes - Bosch IDS181 Instrucciones De Funcionamiento Y Seguridad

BM 2609140889 06-12_BM 2609140889 06-12 6/26/12 10:42 AM Page 10
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when driving (Fig. 1).
BELT CLIP (Optional Accessory)
When the tool is attached to the belt, position
yourself to avoid entanglement with surrounding
objects. Unexpected entanglement could
cause the tool to fall resulting in injury to the
operator or bystanders.
The optional belt clip accessory will allow you to
conveniently attach your tool to your belt. This
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position (Fig. 4).
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward.
1. The charger was designed to fast charge
the battery only when the battery temperature
is between 32˚F (0˚C) and 113˚F (45˚C). If the
battery pack is too hot or too cold, the charger
will not fast charge the battery. (This may
happen if the battery pack is hot from heavy
use). When the battery temperature returns to
between 32˚F (0˚C) and 113˚F (45˚C), the
charger will automatically begin charging.
2. A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be
replaced.
3. Remember to unplug charger during
storage period.
4. If battery does not charge properly:
INSERTING AND RELEASING BATTERy PACK

IMPORTANT CHARGING NOTES

feature will allow you to have both hands free
when climbing a ladder or moving to another
work area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig. 1).
To use clip, turn tool upside down and attach
to your belt.
Press the battery pack release button again
and slide the battery pack completely out of
tool housing (Fig. 4).
FIG. 4
a. Check for voltage at outlet by plugging in
some other electrical device.
b. Check to see if outlet is connected to a
light switch which turns power "off" when lights
are turned off.
c. Check battery pack terminals for dirt.
Clean with cotton swab and alcohol if
necessary.
d. If you still do not get proper charging,
take or send tool, battery pack and charger to
your local Bosch Service Center. See "Tools,
Electric" in the Yellow Pages for names and
addresses.
Note: Use of chargers or battery packs not
sold by Bosch will void the warranty.
-10-