Changing The Contact Points - EYENIMAL SMALL BARK CONTROL Manual De Instrucciones

of the collar (See Diagram 3).
- After the beep sound indicating that the collar is on, a series of beep sounds together with
indicator light flashes is emitted (from 1 to 3) indicating the selected mode.
- Keep the magnetic key in contact with the
- Remove the magnetic key when you have reached the mode you wish. The collar will memorize
your selected mode. Next time you will switch on the collar, your collar will be turned on to the
last mode you previously selected.
Number of beep sounds together
with indicator light flashes
emitted when switching mode
Checking/reloading collar battery
5 beep sounds + indicator light flashes in red 5 times when turning on/off the collar = the battery
is too low.
When the battery is too weak, the product switches to safety mode and the system locks up.
You must charge the battery (full charge takes approximately two hours - see § Charge of the
battery).

Changing the contact points

Two different series of contact points are supplied. The length of the contact points must be
sufficient to have proper contact with the dog's skin, enabling the device to operate correctly
(proper barking detection and correct transmission of the stimulations).
If you have a long-haired dog and the short contact points fitted to the collar in the factory are
inadequate, remove and replace them with the long ones supplied with the kit.
Carefully tighten them manually (do not use a key).
enimal_Small_Bark_Control-fr.indd 17
1
2
3
symbol to run through modes.
Mode
Nr 1 Beep sounds only
Beep sound + progressive
Nr 2
stimulation for sensitive dog
Beep sound + progressive
Nr 3
stimulation for difficult dog
Gb - 17
Operation
25/07/2016 15:3