Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: If fan or supply wires are different colors than indicated, ha
1. To set the code on receiver unit, slide dip switches to
the same positions as set on the remote. (Figure 1)
NOTE: The remote unit has 32 different code
other remote units, simply change the combination code
NOTE: Factory setting is all up. Do not use this position.
WARNING
To avoid possible electrical shock, be sure electricity
s i
u t
n r
e
d
o
f f
t a
h t
e
m
a
(Figure 2).
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION COULD
DAMAGE THIS RECEIVER.
2. Slide the receiver into the hanger bracket before wiring
as shown in figure 3.
3. Connect wires using connectors as shown in Figure 4.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors. Do not operate fan until the blades are in
place. Noise and motor damage could result.
RECEIVER HARDWARE USED:
WIRE
CONNECTORS
How to Wire Your Ceiling Fan
n i
u f
s
e
b
o
x
b
e
o f
e r
w
r i
n i
WARNING
x 8
BLACK
L
WHITE
N
AC
POWER
ON
1
g
Receiver
Unit
NOTE: Supply wires
omitted for clarity
GROUND
WELLOW
HANGER
/ GREEN
BRACKET
HANGER
BALL
Receiver
Figure 4
10
Dip Switch
2
3
4
5
Figure 1
Figure 2
Dip Switch
Figure 3
RED
GRAY
YELLOW
DC MOTOR
BLACK
ANTENNA
MAIN FUSE BOX
Hanger Bracket
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
