OPTIONAL CARDS
INSTALLATION
With the help of a small flat‑tip screwdriver, press horizontally on the right side of the plastic cover and remove it carefully.
To install an L‑PAD BLUETOOTH card or a L‑PAD PLAYER USB MP3 card, connect the cable with 5‑pin connector to the corresponding connector (5‑pin)
on the printed circuit board, as shown here.
To install an L‑PAD PLAYER/RECORDER USB MP3, connect the cable with 5‑pin connector to the corresponding connector (5‑pin) on the printed circuit
board and the cable with 3‑pin connector to the corresponding connector (3‑pin), as shown here.
Now, fit the optional card into the purpose‑designed seat and take advantage of the new functions.
Gently remove the plastic cover
with the help of a screwdriver.
MP3 PLAYER CARD
Using a computer, copy all the MP3 audio files you want into a USB flash drive, even organised into
folders (up to a maximum of 32 GB). Insert a USB flash drive into the purpose‑designed connector on
the card and hold the PUSH & HOLD button for two seconds: the first file in the first folder will start
playing; the display alternates between showing the file number and folder number currently playing.
Press the
▐◄◄
button to skip to the previous track or
(PLAY/PAUSE) button to pause or resume playback, press ■ (STOP) to
to change folder. Use the
►▌▌
stop playing. Press the
(loop) button repeatedly to select the random play, to play the current track repeatedly in sequence or to play the entire playlist
repeatedly in sequence respectively. Turn the 2TK LEVEL control clockwise, taking it to the central position („12 o'clock") and verify that the 2TK TO MAIN
MIX key is pressed. Carefully raise the MAIN MIX control (fader) until you reach the desired listening level.
MP3 PLAYER/RECORDER CARD
Using a computer, copy all the MP3 audio files you want into a USB flash drive, even organised into
folders (up to a maximum of 32 GB). Insert a USB flash drive into the purpose‑designed connector
on the card and hold the PUSH & HOLD button for two seconds: the first file in the first folder will
start playing; the display alternates between showing the file number and folder number currently
playing. You can record the audio signal present at the MAIN MIX output. Press the REC button
once: the player is now in „rec ready" („ready to record") mode and the display shows a flashing
REC; press REC again to start recording. Press the PUSH & HOLD button once to stop recording; the card creates a new folder on the USB drive, called
„FrE01", where the files created will be stored. Use the
to select the random play, to play the current track repeatedly in sequence or to play the entire playlist repeatedly in sequence respectively. Turn the 2TK
LEVEL control clockwise, taking it to the central position („12 o'clock") and verify that the 2TK TO MAIN MIX key is pressed. Carefully raise the MAIN MIX
control (fader) until you reach the desired listening level.
BLUETOOTH CARD
Enable the Bluetooth interface on the mobile device and press the PAIR button on the card.
The mobile device should recognise the Bluetooth device as „BT2.1"; next, make the association
between the two devices. Now you can play your favourite tracks: on the mixer, turn the 2TK LEVEL
control clockwise, taking it to the central position („12 o'clock") and verify that the 2TK TO MAIN
MIX key is pressed. Carefully raise the MAIN MIX control (fader) until you reach the desired listening
level; to adjust the volume on the panel of the card, you can also press the VOL+ and VOL- buttons.
3 pin connector
►►▌
to the next; hold down the same buttons
(PLAY/PAUSE) button to pause or resume recording. Press the
►▌▌
Be sure to connect
each connector in its proper position.
5 pin connector
(loop) button repeatedly
13