Descargar Imprimir esta página

Toyotomi zibro LC-DX320 Instrucciones De Uso página 21

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 62
Without the SAVE setting your heater
!
appro imation as
ell, by adjusting its heating capacity. SAVE is an economy
setting, which you can use when, for instance, you are not present in the room
or to keep it frost-free.
K
THE 'FUEL' INDICATOR
When the UEL indicator appears, it means that there is only fuel left for 10
more minutes. The count-do n of the remaining heating time can be seen in the
information display ¸ ( ig. K). No
¼ you remove the fuel tank and refill it outside the living room (Section B) or
¼ you push the button extension K . By pushing this button, the remaining
heating time
ill e tend to 0 minutes.
The heater will automatically switch back to its lowest position. In the display
the number 0
you will hear an alarm signal every two minutes, warning you to refill the
removable tank. If you do not react, the heater will extinguish by itself. The
heater will also sound a warning signal, when it switches off. The fuel
indicator
ill blink,
display. You can stop this by pressing the
Once the heater has used up all its fuel and extinguished, it will take some time,
after the refill, before the heater is completely ready for use again.
L
THE 'VENT' INDICATOR
When there is insufficient ventilation in the room, the heater shuts off
automatically. When this occurs, e -1 1 is displayed and the VENT indicator
blinking (fig. L). After improving the ventilation of the room (e.g. by opening
a door or window a little more), the heater can be ignited by pushing the
button ¹ again.
M
MAINTENANCE
S itch off the heater and let it cool do n, before you start any maintenance
ork. Also disconnect the plug from the mains. Your heater needs hardly any
maintenance. It is, however, important that you clean the vent filter
vacuum cleaner and the grid
Regularly inspect the fuel filter as well:
1 Remove the removable tank
( ig. M). Some drops may leak from the filter keep a cloth at hand.
2 Remove the dirt by tapping the fuel filter upside-do n against a hard surface.
(Never clean it with water!)
3 Reinstall the fuel filter into the heater.
We recommend that you remove dust and stains from time to time with a damp
cloth, because otherwise these may cause stains that are hard to remove.
!
Do not remove any heater components yourself. Al ays contact your dealer
for repairs. When the power cord is damaged, it may only be replaced by an
authorised fitter. Use a ne
ill maintain the set temperature by
you have t o options:
ill appear,
hich
ill decline to 10. At the arrival of 10,
hile four lines (--:--) are blinking in the information
with a damp cloth, both on a weekly basis.
from the heater and remove the fuel filter
cord of the type H05 VV- .
button ¹ once more.
K: When the FUEL
indicator has appeard,
the information display
will show the number of
minutes of fuel left in
the tank.
is
L: A blinking VENT
indicator is a sign
that you need extra
ventilation.
with a
Fuel filter
4
9
M

Publicidad

loading