Attaching The Cover And Flag; Installing The Tow Bar - Burley Honey Bee Manual De Instrucciones

Attaching the Cover and Flag

1. Attach cover to trailer using provided screws
(Figure 7). Slip the cover D-rings over the
hooked corners of the tow bar receivers
(Figure 8).
2. Slide Flag pole into hole on flag holder. To
release, push button and lift flag pole out
(Figure 7).
Note: Fabric loops are located on the back of the
cover and should be used to attach additional
lights and/or reflectors.

Installing the Tow Bar

1. Slide the tow bar into the tow bar receivers until hole A is aligned with hole
B (Figure 9). The red safety strap bracket should be flush with the front of
the tow bar mount.
2. Insert the retaining pin from the top through the aligned holes (Figure 10).
3. Make sure the retaining pin has locked properly as shown (Figure 11 & 12).
4. Clip the receiver safety strap to the D-ring on the trailer frame (Figure 13).
A
Figure 9
4
ENG
B
Figure 10
Figure 7
Figure 11
Figure 8
Figure 12
Figure 13
CHILD TRAILER