DeWalt DCF887 Manual De Instrucciones página 42

Proper Hand Position (Fig. 5)
WARNING:
To reduce the risk of serious personal injury,
proper hand position as shown.
WARNING:
To reduce the risk of serious personal injury,
securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the main handle (J).
FIG. 5
Variable Speed Trigger Switch (Fig. 2)
To turn the tool on, squeeze the trigger switch (A). To turn the tool
off, release the trigger switch. Your tool is equipped with a brake. The
chuck will stop when the trigger switch is fully released. The variable
speed switch enables you to select the best speed for a particular
application. The more you squeeze the trigger, the faster the tool will
operate. For maximum tool life, use variable speed only for starting
holes or fasteners.
NOTE: Continuous use in variable speed range is not recommended.
It may damage the switch and should be avoided.
Forward/Reverse Control Button (Fig. 2)
ALWAYS A forward/reverse control button (B) determines the direction of the
use
tool and also serves as a lock-off button.
ALWAYS
hold To select forward rotation, release the trigger switch and depress the
forward/reverse control button on the right side of the tool.
To select reverse, release the trigger switch and depress the forward/
reverse control button on the left side of the tool.
The center position of the control button locks the tool in the OFF
position. When changing the position of the control button, be sure
the trigger is released.
NOTE: The first time the tool is run after changing the direction of
rotation, you may hear a click on start up. This is normal and does
not indicate a problem.
Worklights (Fig. 2)
CAUTION: Do not stare into worklight. Serious eye injury could
J
result.
There are three worklights (G) located around the chuck collar (C). The
worklights are activated when the trigger switch is depressed. When
the trigger is released, the worklight will stay illuminated for up to 20
seconds. If the trigger switch remains depressed, the worklights will
remain on.
NOTE: The worklights are for lighting the immediate work surface and
are not intended to be used as a flashlight.
Quick-Release Chuck (Fig. 2, 6, 7)
WARNING: Use only impact accessories. Non-impact accessories
may break and cause a hazardous condition. Inspect accessory prior
to use to ensure that it con tains no cracks.
NOTE: The chuck accepts 1/4" (6.35 mm) hex accessories.
Place the forward/reverse button (B) in the lock-off (center) position or
remove battery pack before changing accessories.
40