Intended Use; Assembly And Operation - Worx Sonicrafter WX685 Traducción De Las Instrucciones Originales

SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Before working with your tool make sure
that no power cords will be damaged.
Avoid danger of injury from the sharp
edges of the accessories.
Accessories can become very hot while
working, presenting danger of burns!
Make sure the tool is unplugged prior
to changing accessories.
Wear protective gloves
High oscillation frequency
Low oscillation frequency
Oscillating Tool
Waste electrical products must not be
disposed of with household waste.
Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling
advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The power tool is intended for sawing and
remodelling wooden materials, plastic, plaster, non-
ferrous metals and fasteners (e.g. nails and clamps)
as well as for working on soft wall tiles and for dry
grinding of small surfaces. It is especially suitable for
working close to edges and for flush cutting.

ASSEMBLY AND OPERATION

Action
Mounting Accessories
Mounting The Sanding Sheet
Mounting The Suction Device
(not supplied)
Operating The On/Off Switch
Using the Variable Speed Dial
The Variable Speed Dial can be used to set the
optimum oscillating frequency according to the
accessories used and the respective application.
Oscillation
Frequency
High oscillation
frequency:
Low oscillation frequency:
Figure
See Fig. A-C
See Fig. D
See Fig. E1-E5
See Fig. F
See Fig.G
Application
Sanding, sawing,
rasping and polishing
stone and metal.
Scraping, polishing
varnishes.
EN
7