Connection
1.
Connect the power cord to ac outlet
2.
Switch on the system to and if the POWER LED indicator is on with red light, it's mean the power
supply is normal. Now your system is ready to play the music.
Top cover assembly
1.
Push the metal bracket to rear side
2.
Connect the metal bracket to the top cover
3.
Connect the hinge of the top cover to the main.
Phono
-
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest
before operating and re-secured again afterwards.
1.
Turn on the system until the " POWER LED " light up.
2.
Set the speed selector to the proper position depending on the record to be
played.
3.
Place the record on the platter (use the spindle adaptor if required).
4.
Lift the tone arm from the rest and slowly move it to the record side. The
platter will start to rotate.
5.
Place the tone arm to the desired position of the record.
6.
Adjust the volume to the desired level.
7.
At the end of record, the platter will automatically stop rotating. Lift the tone arm from the
record and return it to the rest.
8.
To stop manually, lift the tone arm from the record and return it to the rest.
REMARK :
As some kind of record the AUTO-STOP area was out of the unit setting, so it will stop before the last
rack finish. in this case, select the AUTO-STOP switch to " OFF " position, then it will run to the end of
the record but will not stop automatically (turn off the unit by POWER button or switch back the
AUTO-STOP switch to " ON " position to stop the platter rotate). Then put back the tone arm to the rest
position.
Line out connection
You can connect the system to your whole HI-FI system by connecting the line out socket (10) to the
auxiliary input socket with a RCA cable (not included).
- EN-4 -