Assembly - Craftsman 247.770110 Manual Del Operador

Rope
Guide
20-oz. Bottle
of Engine Oil
Wing
Nuts
Lower
Handle
Wing
Nuts
Carriage
Screw
Figure 1
This unit is shipped without gasoline or
IMPORTANT:
oil in the engine. After assembly, see OPERATION
section of this manual for proper fuel and engine oil
fill-up.

ASSEMBLY

Blower
Upper
Chute
Handle
Wing
Nut
Bag
NOTE: Reference to right and left hand side of the
Yard Vacuum is observed from the operating
position. See Figure 1.
This Yard Vacuum has been completely assembled
at the factory, except for the handle, bag, and blower
chute. These parts are shipped loose in the carton.
A pair of safety glasses and a 20-oz. bottle of engine
oil are also included in the carton. See Figure 1.
REMOVING UNIT FROM CARTON
• Cut the corners of the carton.
• Remove all loose parts.
• Remove packing material.
• Lift unit from the rear to discard packing material
from under unit and roll unit out of carton.
• Check carton thoroughly for any other loose
parts.
LOOSE PARTS IN CARTON
• Handle Assembly
• Bag
• Blower Chute
• Safety Glasses (Not Shown)
• A 20-oz. Bottle of Engine Oil
(may be located in bag)
• Operator's Manual
DISCONNECTING SPARK PLUG
Before proceeding with assembly of your new Yard
Vacuum, disconnect the spark plug wire from the
spark plug and ground onto the retaining post on the
engine. This will prevent accidental starting of the
engine. See Figure 2.
Retaining Post
ATTACHING THE HANDLE
• Unfold the upper handle until it aligns with lower
handle. Make sure the rope guide is on the right
side of upper handle. See Figure 1.
5
(See Figure 1)
Spark
Plug Wire
Figure 2