Guarantee; Parts Subject To Wear And Tear - Solo 137SB Manual De Instrucciones

Guarantee; Parts subject to wear and tear; CE Declaration of conformity ;For USA only: ECW Statement

11. Guarantee

The manufacturer guarantees trouble-free quality
and will cover the cost of replacing parts which are
found to be faulty in material or workmanship within
the prescribed guarantee period after the date of
purchase. Please note that specific guarantee
conditions may vary from country to country. If in
doubt, ask your equipment vendor. He is responsible
for guarantee matters.
We hope you will understand that we cannot be
liable for damage resulting from the following causes:
• Non-compliance with the operating instructions.
• Neglecting essential maintenance and repair
work.
• Damage caused by incorrect carburettor
adjustment.
• Wear in normal use.
• Obvious overload by continuously exceeding
the maximum performance limit of the product.
• Using non-authorised tools.
• Use of force, incorrect treatment, misuse and
accidents.
• Damage from excessive heat due to dirt build-
up around the cooling fan housing.
• Attempted adjustments and repairs by
unqualified persons.
• Use of unsuitable spare parts or third party
parts, if these are the cause of the defect.
• Use of unsuitable or stale fuel.
• Damage caused by using the product in the hire
or rental industry.
Normal cleaning, adjustments or maintenance work
fall outside the guarantee provisions.
A service centre authorised by the manufacturer
must carry out all guarantee work.

12. Parts subject to wear and tear

Various parts are subject to application-specific or
normal wear and must be replaced in good time,
when required. The following parts are subject to
normal wear and are not covered by the
manufacturer's guarantee:
• Air filter
• Fuel filter
• All rubber parts which come into contact with
fuel
• Clutch
• Spark plug
• Starter
• Cutting tools
For USA only
Emissions Control Warranty Statement
The Environmental Protection Agency and Solo are
pleased to explain the emission control system on
your small non-road power equipment engine. In the
US new small non- road engines must be designed,
built, and equipped to meet the Environmental
Protection Agency's standards. Solo must warrant the
emission control system on your small non- road
engine for the period of time listed below provided
there has been no abuse, neglect, or improper
maintenance of your small non-road engine.
Your emission control system includes parts such as
the carburetor, the ignition system, and the exhaust
system.
Where a warrantable condition exists, Solo will repair
your small non-road power equipment engine at no
cost to you including diagnosis, parts, and labor.
Manufacturers Warranty Coverage
Solo's small non-road power equipment engines are
warranted for a period of two years. If any emission
control related part on your engine is defective, the
part will be repaired or replaced by Solo.
Contact Information for Authorized Service Center
Locations, Replacement Parts,
Warranty and Technical Information
Warranty repairs must be completed by a SOLO
Authorized Service Center.
SOLO USA, Inc.
5100 Chestnut Avenu
Newport News, VA 23605
1-800-765-6462
techserv@solousa.com
ENGLISH 21