Saivod VSC4514D Manual Del Usuario página 21

panel " " and " " to adjust the temperature by 1℃ among 5-10℃/10-18℃.
You can tune the interior light on or off by pressing the "Light" button.
CARE AND MAINTENANCE
Cleaning your wine cooler
 Unplug the wine cooler and remove the bottles.
 Wash the inside with a warm water and baking soda solution. The solution should be about 2
tablespoons of baking soda to a quart of water.
 The outside of wine cooler should be cleaned with mild detergent and warm water.
 Draw out the water box at the back bottom, and wash.No need to maintain.
Moving your wine cooler
 Remove all the bottles.
 Securely tape down all loose items inside your wine cooler.
 Turn the leveling legs up to the base to avoid damage.
 Tape the door.
 Be sure the wine cooler stays in the upright position during transportation.
PROBLEM DISPOSAL
You can solve many common wine cooler problems easily, saving you the cost of a possible service call.
Try the suggestion below to see if you can solve the problem before calling the service center.
PROBLEM
Wine cooler does not operate.
Wine cooler is not cold enough.
The light does not work.
Vibrations.
The wine cooler seems to make too
much noise
The door will not close properly.
LED could not display.
LED display error.
Buttons are not functional.
VSC4514D.indd 21
POSSIBLE CAUSE
Not plugged in using different voltage. The circuit
breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The wine cooler does not have the correct clearance.
Check the service center.
Check to assure that the wine cooler is level.
The wine cooler is not level.
Check the fan.
The wine cooler is not level.
The doors were reversed and not properly installed.
The seal is weak.
The shaves out of position.
Main control board does not work.
PCB Problem.
There is some problem with the plug.
Weak quality of display.
Temperature point is out off.
Temperature controller panel is damaged.
GB
21
8/26/2016 2:10:37 PM