Charging Battery Pack - Dremel 7300-PGT Instrucciones De Funcionamiento Y Seguridad

2610046266_7300-PGT 3/21/17 10:17 AM Page 14
- Charging the battery
The battery pack is not fully charged. Be sure to charge
pack prior to initial use. For best re sults on first charge,
charge pack overnight.
1. Make sure the switch 3 in the "OFF" (O) position.
Squeeze release tabs 2 on both sides of battery
pack 1, and remove pack from the tool (Fig. 1).
2. Align the battery pack 1 with the charger 4 as
shown, squeeze release tabs 2, insert battery pack
into charger and release pressure on tabs so it
locks in place (Fig. 2).
4. Plug charger into the power source. The charger
indicator light 5 will light up green, indicating that
connection has been made and the battery pack is
charging. The indicator light will blink while charg-
ing. The indicator light will turn solid when charg-
ing is complete (Fig. 2). Under normal tool usage
the battery requires 3 hours charging time to
reach full capacity.
FIG. 1
3
14

Charging battery Pack

5. When charging is completed, squeeze release tabs
6. Align the battery pack with the tool as shown.
- Important Charging Notes
If you anticipate long periods of non-use for your tool
it's best to unplug your charger and battery pack from
its power source. Unplugging the charger will extend
the life expectancy of the charger and battery pack.
The battery pack accepts only about 80% of its maxi-
mum charge capacity with its first charge; or, after pro-
longed storage it will also require additional time on the
first charge. However, after several charge and dis-
charge cycles, the batteries should be up to full charge
capacity and delivering maximum performance.
1 2
2 on battery pack and remove pack 1 from charger
(Fig. 2).
Squeeze release tabs 2, insert battery pack 1 into
the tool, and release pressure on tabs 2 so it locks
in place (Fig. 1).
FIG. 2
1
2
4 5