DeWalt DP3700 Manual De Instrucciones página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(Troubleshooting Codes cont.)
CODE
POSSIBLE CAUSE
17
Spray wand not in low pressure.
18
Chemical filter clogged.
19
Chemical screen not in cleaning solution.
20
Chemical too thick.
21
Worn seal or packing.
22
Chemical build up in chemical injector.
23
Worn or obstructed valves.
24
Worn unloader piston.
25
Worn or broken o-ring.
26
Loose hose connection.
27
Piston packings worn.
28
Pump head or tubes damaged from freezing.
29
Oil seals worn.
30
Loose drain plug.
31
Worn drain plug o-ring
32
Worn fill plug o-ring.
33
Pump overfilled.
34
Incorrect oil used.
35
Vent plug is clogged.
36
Defective E-Z start valve.
POSSIBLE SOLUTION
See Spray Wand Nozzles under Operation.
Clean filter.
Make sure end of chemical hose is fully submerged into cleaning
solution.
Dilute chemical. Chemical should be the same consistency as water.
Have parts cleaned or replaced by authorized service center.
Have replaced by an authorized service center.
Have replaced by authorized service center.
Have replaced by authorized service center.
Check and replace.
Tighten.
Have replaced by authorized service center.
Have replaced by authorized service center.
Have replaced by authorized service center
Tighten.
Check and replace.
Check and replace.
Check for correct amount.
Drain and fill with correct amount and type of oil.
Clean vent plug; blow air through it to remove any blockage. If
prob lem per sists, replace plug.
Have replaced by authorized service center
19

Publicidad

Tabla de contenido
loading

Tabla de contenido