DHC BT1000 El Manual Del Propietario página 9

RECHARGE & RETEST
*Battery is discharged, the battery condition
cannot be determined until it is fully charged.
Recharge & retest the battery.
BAD & REPLACE
*The battery will not hold a charge. It should be
replaced immediately.
BAD CELL & REPLACE
*The battery has at least one cell short circuit. It
should be replaced immediately.
LOAD ERROR
*The tested battery is bigger than
2000CCA/SAE or 200AH. Or the clamps are
not connected properly. Please fully charge the
battery and retest after excluding both previous
reasons. If reading is the same, the battery
should be replaced immediately.
14. SOC & SOH Display: Press directional keys to see SOC & SOH:
GOOD & PASS
SOC: xx.xx V
15. Test Code:
Press <Enter> to get Test Code.
90%
9
9
RECHARGE &
RETEST
VOL: xx.xx V
CCA: xxxx CCA/SAE
IR: xx.xx mΩ
BAD & REPLACE
VOL: xx.xx V
CCA: xxxx CCA/SAE
IR: xx.xx mΩ
BAD CELL &
REPLACE
VOL: xx.xx V
CCA: xxxx CCA/SAE
IR: xx.xx mΩ
LOAD ERROR
GOOD & PASS
SOH: xxxx CCA/SAE
90%
CODE
xxxxxxxxxxxx